TSX TOOL terminalen trekker set auto 11-delig

Aquest kit és apte per a la majoria de terminals estàndard en connectors automotrius i domèstics, tant de pins rodons com plans. Tanmateix, no cobreix connectors d’alta corrent o terminals de dimensions superiors a 4 mm de diàmetre, cosa que en limita l’ús per a vehicles industrials o aplicacions d’alta potència.

Les eines estan fabricades en alumini anoditzat, cosa que proporciona lleugeresa i resistència a la corrosió. Cada extractor fa entre 60 i 90 mm de llarg, amb un gruix d’1 a 3 mm segons el model, i un pes aproximat de 5 a 10 g per unitat.

El manteniment és mínim: es recomana netejar els extractors després de l’ús per eliminar residus i evitar l’oxidació en ambients humits. No cal lubricar ni esmolat, però es suggereix guardar-los en un lloc sec per allargar-ne la vida útil. No aplicar forces excessives evita deformacions.

Sempre desconnecteu la bateria i assegureu-vos que els conductors estiguin sense tensió abans de procedir; l’ús inadequat pot generar curtcircuits o descàrregues elèctriques. A més, no s’han de forçar les peces per evitar danys als terminals i a l’eina.

This kit is suitable for most standard terminals in automotive and domestic connectors, both round and flat pins. However, it does not cover high-current connectors or terminals larger than 4 mm in diameter, which limits its use for industrial vehicles or high-power applications.

The tools are made from anodised aluminium, which provides lightness and corrosion resistance. Each extractor measures between 60 and 90 mm in length, with a thickness of 1 to 3 mm depending on the model, and an approximate weight of 5 to 10 g per unit.

Maintenance is minimal: it is recommended to clean the extractors after use to remove residue and prevent oxidation in humid environments. Lubrication or sharpening is not necessary, but storing them in a dry place is advised to extend their service life. Avoiding excessive force prevents deformation.

Always disconnect the battery and make sure the conductors are de-energised before proceeding; improper use can cause short circuits or electric shock. In addition, parts should not be forced to avoid damage to the terminals and the tool.

This kit is suitable for most standard terminals in automotive and domestic connectors, both round and flat pins. However, it does not cover high-current connectors or terminals larger than 4 mm in diameter, which limits its use for industrial vehicles or high-power applications.

The tools are made from anodised aluminium, which provides lightness and corrosion resistance. Each extractor measures between 60 and 90 mm in length, with a thickness of 1 to 3 mm depending on the model, and an approximate weight of 5 to 10 g per unit.