Set kabeldoorvoeren 180 stuks met 8 maten in opbergdoos

Aquests passacables solen fabricar-se en goma sintètica (típicament NBR o EPDM). Això els confereix bona resistència al desgast mecànic, elasticitat i tolerància a temperatures entre -30 °C i 100 °C, ideals per a la majoria d’aplicacions domèstiques i industrials lleugeres, tot i que no es recomana per a ambients amb olis o temperatures extremes.

Aquests passacables són aptes per a panells amb un gruix d’aproximadament 1 a 3 mm. Per a gruixos superiors, l’ajust podria no ser hermètic i la peça podria deformar-se o sortir, perdent efectivitat.

Es recomana utilitzar una broca o troquel del diàmetre indicat per a cada passacable (per exemple, 6.35 mm, 7.94 mm, etc.), netejar bé les vores i pressionar la peça fins que assenti completament al forat. S’ha d’evitar forçar-los en forats de diàmetre no compatible, ja que es pot danyar la goma o el panell.

Aquest set és adequat per a ús en interiors o zones no exposades directament a l’aigua. Els models reforçats per a exterior solen ser de materials més resistents (com silicona, amb perfil gruixut o doble llavi) i ofereixen una major estanquitat davant l’aigua i els raigs UV, sent preferibles en aplicacions a la intempèrie o on es requereixi més protecció.

These cable grommets are usually made from synthetic rubber (typically NBR or EPDM). This gives them good resistance to mechanical wear, elasticity and tolerance to temperatures between -30°C and 100°C, making them ideal for most domestic and light industrial applications, although they are not recommended for environments with oils or extreme temperatures.

These cable grommets are suitable for panels with a thickness of approximately 1 to 3 mm. For greater thicknesses, the fit may not be watertight and the part could deform or come loose, reducing effectiveness.

It is recommended to use a drill bit or punch of the diameter specified for each grommet (for example, 6.35 mm, 7.94 mm, etc.), clean the edges thoroughly and press the part in until it sits fully in the hole. Avoid forcing them into holes of an incompatible diameter, as this may damage the rubber or the panel.

This set is suitable for indoor use or areas not directly exposed to water. Reinforced outdoor models are usually made from more durable materials (such as silicone, with a thick profile or double lip) and offer greater water and UV resistance, making them preferable for outdoor applications or where greater protection is required.

These cable grommets are usually made from synthetic rubber (typically NBR or EPDM). This gives them good resistance to mechanical wear, elasticity and tolerance to temperatures between -30°C and 100°C, making them ideal for most domestic and light industrial applications, although they are not recommended for environments with oils or extreme temperatures.

These cable grommets are suitable for panels with a thickness of approximately 1 to 3 mm. For greater thicknesses, the fit may not be airtight and the part could deform or come loose, reducing effectiveness.